How to Replace Handle Bar Grip Tape on a Bike



We are searching data for your request:

Forums and discussions:
Manuals and reference books:
Data from registers:
Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

My grip tape came loose.

Got some new tape.

It comes with grip tape, tube caps and end tape. You can just use electrical tape (black plastic tape) if you don't want the logos.

First get everything out of the way so you can remove your old tape. My bike has these shifter brakes and I could flip the plastic up.

Then I peeled the old tape off. Take note of any tricky ways the old tape goes around your bars.

Start wrapping by making a slight cone at the end of the handle.

When you get to the brake go up through the inside.

Then over the top.

Then under inside.

Then over the top from the outside.

Continue.

I wrapped an extra piece under the wrapping for some cushion.

Put the caps on the ends.

Use the included electrical tape or your own to hold the grip tape at the center of the handle bars. All done!


Watch the video: Removing and Wrapping New Handlebar Tape


Comments:

  1. Myles

    There is no need to try everything

  2. Arlo

    You are not right. I am assured. I can defend the position. Write to me in PM, we will communicate.

  3. Earm

    I saw something similar in English-language blogs, on the Runet about this somehow you will not see posts very often.

  4. Beagan

    Nothing!



Write a message


Previous Article

How to bake cranberry scones

Next Article

How to make frozen peanut butter bites